The Mini/Blower Pusher is the lightweight, low-cost, portable solution for istallation of fiber cable. Designed for shorter runs, in the “last mile” section of a difficult installation and is driven using a cordless, corded or pneumatic drill.
The unit can install fiber optic cables with diameters from 0.23″ (5.8mm) to 0.5″ (12.7mm) into microduct, 10mm to 18 mm or traditional duct from 0.5″ (12.7mm) to 1.5″ (38.1mm). The unit can be further configured to push/install duct rod into conduit and inner duct.
The Air Stream has been designed to maximize protection for micro cables with a compliant double drive concept, backed by the latest technology in servo controls to provide precise control of torque and speed
Cable Diameter: 2.5 to 11mm
Tube Size (Outside Dia): 5 to 18mm
Cable Speed (Adjustable): 0-260 ft/min (0-80m/min)
Air Pressure: 145-215 psi (10-15 Bar)
Power Requirement: 110/220 Volt AC
Width: 11.8 in. (300mm)
Length: 18 in. (460mm)
Height: 10.6 in. (270mm)
Ditch Witch C24X Pedestrian Trencher, 22HP Honda GX390 Gas Engine, Hour Meter, Electric Start, Hydrostatic, Infinitely Variable Speed Ground Drive, Color Coded Controls, CX Rubber Track Design with Pin Lock Parking Brake, 36″ Manual Adjust Boom (141-791) with 35K 2 Pitch Shark Control Chain Wide(137-236), Restraint Bar
The Single Size Junction Box comprises an aluminum base and lid that form a pressurized air chamber into which one end of an existing occupied innerduct can be attached. The existing cable can exit the box through an opening that has 3 cable seal slots, one of which will house the seal to suit the size of the existing cable. Works with 1.25″, 1.50″ and 2.00″ duct Sizes